Neutrona Wand DIY PCB

This listing is for a full replacement neutrona wand board. Designed for full size pack. This is a total DIY Kit. You can build the electronic kit yourself and we will be using off the shelves component that easily available on aliexpress. The PCB is designed to use JST-XH for connectors or you can just directly solder to it like i did. PCB installation will be provided.

Features :

• 28 segment led bargraph for wand.
• Only two wires from wand to pack; you can use neutrik quick disconnect
• Volume control on the wand dial knob
• Activate toggle to enable/disable Intensify button press
• Top toggle to turn wand power on/off
• Bottom toggle to turn wand on/off
• Intensify button on both wand and barrel end to trigger firing
• Automatically connects to ectogears other boards
• Audio control Play/Next/Prev from the wand

LED :

• • Barrel end (beside barrel Intensify button)
  • Front led
  • Top led x 2
  • SloBlo led
  • Vent led
  • Barrel tubing led WS2812B strip 15 bit

Custom configuration :

Customizable firing trigger behaviour. Use a phone or pc to connect directly to board to customize the timing.

• • Adjustable firing,overheat,venting timing
  • Normal firing or Firing Resume ( if resume, next press will resume where it left off previously)
  • Skip initial startup
  • Skip venting startup ( if enabled, after venting, went straight to Idle) 
  • Firing delay

Do-It-Yourself ?

• Yes. This is a total DIY project. You will need to know basic electronics and able to solder.
• You will require to get remaining components. They can be cheaply purchase at Aliexpress.
• The code is already uploaded into the boards.
• Neutrona pcb size is 80mm x 46mm
• Bargraph pcb size is 34mm x 13.7mm

What included ?

• 1 pc of Neutrona wand PCB
• 1 pc of Bargraph PCB
• 1 pc of Microcontroller
• 2 pcs of neopixel 1bit led
• 5 pcs of 5mm led
• 1 pc of capacitor